13-4-poluosi-snyatie-i-ustanovka.html
13.4. Semi-axes - removal and installation1. Lift the car and establish on supports.
2. Remove a wheel.
3. Remove the automatic interlock device.
4. Get from a semi-axis pin a lock ring.
|
2. З Details of the device of an automatic interlock 1. Lock-nut of a nave 2. Lock washer 3,8. Spring ring 4. Washer 5. A lead In 6. Washer And 7. A washer In 9. Lead And 10. Spring 11. Sealing ring 12. Case 13. Details of the device of an automatic interlock * we Grease
|
|
2.4 After removal of the case get a lock ring, washers and a lead In 1. A lead In 2. Lock ring 3. Washer And
|
|
3.6 Put labels on the case of the sliding hinge and on the reducer case then unscrew bolts
|
5. Remove a washer and a lead of Century.
6. Unscrew bolts of fastening of a semi-axis to a reducer (photo).
7. Unscrew the bottom bolt of the shock-absorber.
8. Remove a support (Hl. 10), take aside and fix.
9. Disconnect steering draft.
10. Slightly will hang out the bottom lever a jack. Unscrew nuts and bolts and disconnect spherical support of levers. Carefully remove a semi-axis assembled with a rotary fist.
11. Beat out a semi-axis from a fist (photo).
12. At detection of defects on details disassemble a semi-axis (see below).
13. Installation is carried out upside-down. Check axial люфт semi-axes (photo). If люфт exceeds norm, pick up a lock ring on thickness (see. Specifications).
|