|
14-3-kolodki-diskovykh-perednikh-i-zadnikh-tormozov-zamena.html
14.3. Blocks disk (forward and back) brakes - replacement
|
Attention!
Blocks change only in a set on one axis. When cleaning blocks a dust and dirt to delete with wiping by rags moistened in alcohol, it is forbidden to blow.
|
1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Unscrew a bolt of the bottom axis of the cylinder (photo).
3. Cast away a support up (photo).
4. Remove holders, laying and blocks. Pay attention to an initial arrangement of details.
5. Grease contact surfaces of a support with silicone greasing (photo).
6. Establish new internal blocks and laying.
7. Lower a support and displace outside (photo).
8. Again lift a support and establish new external blocks and laying (photo).
E.Opustite a support also tighten an axis bolt with the set moment.
10. Further operations are carried out upside-down. Check liquid level if necessary restore. Check work of brakes.
|