|
15-21-rulevye-tyagi-snyatie-i-ustanovka.html
15.21. Steering drafts - removal and installation1. Lateral drafts, cross-section draft, a soshka and the pendular lever (photo) belong to steering drafts.
2. All steering drafts can be removed assembled with the pendular lever and a soshka. After dismantle of drafts it is necessary to check corners of installation of wheels. Nuts of tips finally tighten after car lowering.
Lateral drafts
3. Rasshplintuyte also unscrew nuts (photo).
|
|
20.3 Details of lateral draft 1. External tip 2. Collar 3. Carving plug 4. Internal tip
|
4. Vypressuyte fingers of tips of drafts a special stripper (photo) also get draft.
5. Check люфт in spherical fingers, if necessary fingers replace.
6. If necessary disassemble drafts for what designate the provision of tips in the plug, unscrew bolts of collars and turn out both tips.
7. Assembly and installation are carried out upside-down. If the removed tips are established, combine the labels put before dismantling. If new drafts are established, expose the size A on the taken drafts (photo). After assembly check and adjust corners of installation of wheels.
|
|
20.9 Details of the pendular lever
1. Cover
2. Arm
3,6. Plug
4. Mzyatnikovy lever
5. Butterdish cap
7. Washer
8. Nut
|
|
|
20.4 Vypressovyvaniye of a tip finger
|
|
|
20.7 The size A which should be exposed on new drafts
|
|
|
21.1 Corners of installation of forward wheels
1. Vertical
2. Line parallel to an axis of symmetry of the car
3. Disorder
4. Axis of spherical support of a suspension bracket
5. Longitudinal tilt angle of an axis of turn
6. Convergence of wheels
|
Pendular lever
8. Люфт in the pendular lever it is eliminated with installation of new plugs.
9. Unscrew bolts of fastening of an arm of the lever to a frame (photo).
10. Rasshplintuyte also unscrew a nut, выпрессуйте a finger of the pendular lever from cross-section draft (photo).
11. If it is necessary to replace plugs, unscrew a nut, remove a washer and remove the lever from an arm, get plugs. Replace plugs and collect the lever.
12. Installation is carried out upside-down. Tighten all nuts with the set moment.
Cross-section draft
13. Rasshplintuyte also unscrew all nuts of cross-section draft.
14. Vypressuyte fingers also get draft.
15. Check a condition of plugs of draft, if necessary replace.
16. Installation is carried out upside-down.
Drafts of a steering assembled
17. Unscrew a nut of a soshka and press a soshka from a reducer shaft.
18. Unscrew bolts and remove the pendular lever.
19. Rasshplintuyte also unscrew nuts of lateral drafts on rotary fists, выпрессуйте fingers.
20. Remove all drafts.
21. Installation is carried out upside-down
|