Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and maslosjemny caps - replacement
3.10. A soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






3-4-kryshka-golovki-cilindrov-snyatie-i-ustanovka.html

3.4. A cover of a head of cylinders - removal and installation

1. Remove the air filter.
2. Disconnect from candles of a wire and take aside together with arms.
3. Disconnect a hose of the vacuum amplifier.
4. Unscrew bolts of a cover (photo).
5. Uncover, having carefully opened consolidation.
6. Clear a cover of the remains of consolidations.

4.4 Cover of a head of cylinders


4.9 An order of an inhaling of a cover of a head of cylinders on the KS4 engine: at the 1st stage tighten bolts 1 and 2 with the moment of 3 N of m, then tighten all bolts with the moment of 6,5-9 N of m in that order


7. Put hermetic on the demountable planes of a cover and a head of cylinders, "leading round" hermetic bolts from the inside.
8. Establish laying, a cover and tighten bolts with the set moment. Evenly tighten nuts in three - four receptions with the set moment (photo).
9. Other procedures are carried out upside-down.

«previous page
3.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
following page»
3.5. The roller with yokes - removal and installation