Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






4-2-vidy-remontnykh-rabot-vypolnyaemykh-bez-demontazha-dvigatelya-s-avtomobilya.html

4.2. Types of the repair work which is carried out without dismantle of the engine from the car

Without dismantle it is possible to replace laying of soaking-up and final collectors, laying of the oil pallet, a head of the block of cylinders, epiploons of a cranked shaft. It is possible to remove such units as soaking-up and final collectors, the oil pallet, the oil pump, the pump of cooling liquid, a starter, the generator, the distributor of ignition, a detail of the mechanism of a gazoraspredeleniye, units of fuel system and a head of the block of cylinders. In extreme cases when there is no necessary equipment, without removal of the engine it is possible to replace piston rings, pistons, rods and shatunny loose leaves. However, to perform these works without dismantle and complete dismantling of the engine extremely it is not recommended, as are required cleaning of accompanying details, and also carrying out preparatory activities on assembly.

«previous page
4.1. General information
following page»
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.