Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
6.1. Cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The sensor of temperature of liquid - check and replacement
6.10. Heating system - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Central air - general information
6.14. Central air - service
6.15. The proof-reader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






6-13-sistema-kondicionirovaniya-obshhie-svedeniya.html

6.13. Central air - general information

Consists of the compressor, the condenser, a moisture separator and the evaporator (photo). On cars since 1993 of release the system is filled with a coolant of FM34a which does not destroy an ozone layer of the atmosphere. This coolant does not mix up with R12 coolant therefore to fill systems containing R12 with coolant R-134a it is forbidden. For compensation of turns of the engine at turning on of the conditioner in a power supply system the proof-reader of idling is provided. Management of an air stream from the conditioner is provided with handles on the forward panel.

13.3а Central air of cars of early release
1. The valve for highway pumping (low pressure)
2. Valve of a high pressure
3. Moisture separator
4. Compressor
5. Condenser


13.3б Central air of cars of late release 1. The valve for highway pumping (low pressure) 2. Valve of a high pressure 3. Compressor 4. Condenser 5. Fusible insert



«previous page
6.12. A heater radiator - removal and installation
following page»
6.14. Central air - service