|
6-17-kompressor-snyatie-i-ustanovka.html
6.17. The compressor - removal and installation1. Transfer management rychazhka to the provision of the maximum cooling, open windows and sustain the compressor included on 10 mines idling.
|
|
15.5 The adjusting screw of the proof-reader of idling on the injector engine
1. Screw
2. Electromagnetic valve of the proof-reader
|
|
|
16.3 Conditioner moisture separator
1. A tube from the condenser
2. Final tube
3. Pressure sensor
4. Collar bolt
|
2. Disconnect the battery from weight and remove the ignition distributor.
3. Unscrew a bolt of a natyazhitel of a belt on a compressor pulley, turn an adjusting bolt and take a belt (photo).
4. Disconnect from the compressor of a tube of the highway (photo).
5. Disconnect from the compressor all wires. -
6. Unscrew bolts and take the compressor from an arm (photo).
7. Get the compressor from a compartment.
|
Attention!
In order to avoid breakage working position of the compressor should not be broken for the period of more than 10 minutes. If normal situation nevertheless was broken, establish the compressor into position and turn a shaft on some turns.
|
8. Installation is carried out upside-down. At accession of tubes replace sealing rings. Fill the conditioner in car-care center.
|
|
17.3 A bolt натяжитапя on a pulley of the compressor (And) and an adjusting bolt (In) on the V6 engine
|
|