Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
6.1. Cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The sensor of temperature of liquid - check and replacement
6.10. Heating system - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Central air - general information
6.14. Central air - service
6.15. The proof-reader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system


6.3. The thermostat - removal and

1. The thermostat is mounted in a forward part of a soaking-up collector on 4-cylinder engines, or in a forward right part of the engine (V6).
2. Merge cooling liquid.
4-cylinder engines
3. Remove the air filter and the top hose of a radiator.
4. Unscrew bolts of a cover of the thermostat.
5. Get the thermostat, having paid attention to its orientation (photo).
6. Carefully remove old consolidation.
7. On a cover of the thermostat put the thin roller of silicone hermetic.
8. Establish laying on a cover.
9. Establish the thermostat (photo), a cover, dress the plug of a wire of connection with weight and tighten bolts.
10. Establish all details, fill in liquid, and, without closing a radiator a stopper, warm up the engine. Add liquid and wrap a stopper.
V6 engine
11. Remove the fan with a casing and belts of hinged units. Lift the car.
12. Disconnect the bottom hose from a branch pipe for what unscrew a bolt of an arm and weaken a collar.
13. Weaken the second collar and remove a branch pipe
14. Unscrew bolts and uncover (photo).

3.17 Thermostat cover. The arrow at installation should be turned up

15. Get the thermostat, having paid attention to its arrangement, and remove consolidation.
16. Establish the thermostat a spring towards the engine.
17. Establish laying, having greased with hermetic, dress a cover (photo) and tighten bolts.
18. Establish other details, fill in liquid, warm up the engine and be convinced of lack of a leak.

«previous page
6.2. Antifreeze - general information
following page»
6.4. A radiator - removal and installation