Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
6.1. Cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The sensor of temperature of liquid - check and replacement
6.10. Heating system - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Central air - general information
6.14. Central air - service
6.15. The proof-reader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






6-9-datchik-temperatury-zhidkosti-proverka-i-zamena.html

6.9. The sensor of temperature of liquid - check and replacement

Check
1. The sensor represents the thermoresistor which has been consistently connected to the index of temperature.
2. The sensor will screw in the right forward corner of a soaking-up collector.
3. If the index does not register temperature, check safety locks and a chain. For this purpose disconnect from the sensor a wire and connect to weight. Include ignition and in some seconds switch off. If the arrow of the index deviated in Hot sector, the sensor is faulty. Otherwise the index or a chain is faulty.
4. At temperature 60°С resistance of the sensor of 70-90 Ohm, and at 100°С-24 0м.
Replacement
5. Not cooled down engine merge liquid and disconnect a wire from the sensor.
6. Screw the sensor and turn new, it is reliable zatya-nita not to use Hermetic.

«previous page
6.8. The pump of cooling liquid - removal and installation
following page»
6.10. Heating system - general information