7-12-korpus-drosselnojj-zaslonki-dlya-sistem-s-predvaritelnym-vpryskom.html
7.12. The butterfly valve case (for systems with preliminary injection of TBI of systems) removal and installationRemoval
1. Execute a decompression and disconnect the battery from weight.
2. Merge about 1 l of liquid.
3. Remove the air filter.
4. Disconnect from draft of a butterfly valve a cable of a drive of a zaslonka and a cable круизконтроля (photo).
5. Disconnect hoses of a regulator of pressure and a dilator of fast idling, unscrew 4 nuts and cнимите the case with laying.
|
10.22а the Arrangement of units injection system with preliminary preparation of gas mixture on the engine V6 1. Tank (versatile person) 2. Tank (lorry) 3. Seat of the assistant 4. Exhaust pipe 5. Sensor of exhaust gases 6. A tank with an absorber 7. C
|
|
10.22б the Arrangement of units injection system with preliminary preparation of gas mixture on 4цилиндровом the engine 1. Seat of the assistant 2. Emergency relay 3. Details of system of injection: Sensor of speed of a stream Sensor of turn of a zaslonka Switch хо
|
|
1O.22b Details of the case of a butterfly valve (till 1989)
|
|
12.4а For removal of the case disconnect the specified cables, hoses and sockets...
|
Installation
6. Installation is carried out upside-down. Check correctness of connection of all cables, hoses and sockets.
7. Start the engine and be convinced of lack of a leak of fuel about nozzles. Check idling turns. Warm up the engine and add liquid.
|
13.2 Laying and sealant of wires of a nozzle 1. Laying 2. Sealant
|
|
13.4а Removal of a nozzle 1. Opravka
|
|
12.4б... also unscrew 4 nuts
|
|