Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. Ignition system general information
8.3. Ignition system check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of start-up of the engine general information
8.9. System of start-up of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. Charge system general information
8.14. Generator leaving and precautionary measures
8.15. Charge system check
8.16. Generator removal and installation
8.17. Tension and brush regulator replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






8-16-generator-snyatie-i-ustanovka.html

8.16. Generator removal and installation

1. Disconnect the battery from weight. Lift a car front.
2. Designate and disconnect wires from generators
Remove a belt.
3. Unscrew an adjusting bolt and a fastening bolt.
4. Get the generator from the bottom.
5. Installation is carried out upside-down.

16.2 Generator details (without a back dustproof cover) 1. Coupling bolt 2. Back cover 3. Shchetkoderzhatel 4. Rectifier 5. Case of the forward bearing 6. Rotor 7. Regulator 8. Stator 9. Back bearing 10. Forward bearing 11. Forward cover 12. Шк


16.4 Nuts of fastening of a stator


16.5а the Arrangement of brushes before the soldering


16.5б Places of the soldering of brushes


16.6 The regulator fastens to the rectifier the soldering (And) and a rivet (In)




«previous page
8.15. Charge system check
following page»
8.17. Tension and brush regulator replacement