Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. Ignition system general information
8.3. Ignition system check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of start-up of the engine general information
8.9. System of start-up of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. Charge system general information
8.14. Generator leaving and precautionary measures
8.15. Charge system check
8.16. Generator removal and installation
8.17. Tension and brush regulator replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






8-5-raspredelitel-ustanovka.html

8.5. Distributor installation

If after distributor removal position of the crankshaft was not broken
1. Turn a begunok in the situation designated before removal of the distributor.
2. Establish the distributor, having slightly turned I run a nok that the flute on the distributor entered into gearing with the drive roller
3. If position of the case of the distributor concerning the block did not change, and fixing openings coincided. that the put labels on a begunka and on the case of the distributor should settle down opposite to each other.
4. Tighten fastening bolts with the set moment.
5. Put a cover and attach wires.
6. Check ignition installation.
If after distributor removal position of the crankshaft was broken
7. Expose the piston 1 го the cylinder in the provision VMT of a step of compression.
8. Establish on the distributor a cover. Define a place where the conclusion of a wire of the 1st cylinder of g settles down designate a label on the distributor case.
9. Uncover, turn a begunok, having arranged it opposite to a label.
10. Put a cover and attach wires
11. Check ignition installation.

«previous page
8.4. Distributor removal
following page»
8.6. Sensor of rotation of the crankshaft check