Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
11.1. Specifications
11.2. General data
11.3. Draft of management of transmission - adjustment
11.4. The blocking switch - check and adjustment
11.5. Kick-down - the switch - adjustment
11.6. A rod of a vacuum diaphragm - adjustment
11.7. A back epiploon - replacement
11.8. Automatic transmission - removal and installation
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 







Как Заработать на кликах в интернете - 5 лучших сайтов в Москве | Какой тариф для мобильного интернета выбрать, yota в россии .

11-5-kick-down-pereklyuchatel-regulirovka.html

11.5. Kick-down - the switch - adjustment

1. The switch is intended for food giving on an electromagnetic drive of transition to a low gear by pressing a butterfly valve pedal to the full. If the switch is not adjusted, switching on a low gear occurs at partially open butterfly valve.

4.3 The typical scheme of connection of kick-down - the switch
4.3 The typical scheme of connection of kick-down - the switch


5.4 Adjustment of a rod of a vacuum diaphragm 1. A saddle (the valve should be pressed to a saddle) 2. Case wall Z.Shtok 4. Plate of the case of the throttle valve 5. Throttle valve
5.4 Adjustment of a rod of a vacuum diaphragm 1. A saddle (the valve should be pressed to a saddle)     2. Case wall Z.Shtok 4. Plate of the case of the throttle valve 5. Throttle valve


2. Include ignition and press a butterfly valve pedal to the full, - characteristic click thus should be listened.
3. If click is absent, release a lock-nut (the switch is mounted over a pedal), press a pedal to the full and submit the switch before click (at an emphasis to the probe).
4. Tighten a lock-nut and check adjustment.
5. If the switch is adjusted, but switching on a low gear does not occur, check short circuit of contacts of the switch and tension existence on it.
6. If tension is present and contacts become isolated, address in car-care center for check of a chain of the switch and an electromagnetic drive.

«previous page
11.4. The blocking switch - check and adjustment
following page»
11.6. A rod of a vacuum diaphragm - adjustment