17-25-termoehlement-obogreva-zadnego-stekla-snyatie-i-ustanovka.html
17.25. A thermoelement of heating of back glass - removal and installation1. The thermoelement consists of a set horizontal a provolok, introduced in glass at a formation stage.
2. A provolok it is possible to eliminate small damages independently, to remove glass it is not required.
3. To check work of a heater of back glass start the engine and include a heater.
4. Connect to weight one of wires of a control lamp, and other wire concern a heater wire.
5. Displace a wire along a wire from right to left, - brightness of a luminescence of a lamp thus should accrue. If brightness of a lamp is identical on both ends of a wire of a thermoelement, it is necessary to check connection of a heater with weight. Everything a wire should be checked not less than two places.
6. Repair of a heater needs special carrying-out paste with silver powder (is available on sale).
7. Switch off a heater and wait cooling.
8. Slightly заполируйте the damaged site a soft steel sponge, wipe alcohol.
9. Paste pieces of a sticky tape from both parties of the damaged site so that the gap between pieces in accuracy coincided with the wire route on the damaged site.
10. Dip into paste a poster feather and carry out the line on a gap between tape pieces so that the paste strip blocked the damaged site a little.
11. Carefully remove pieces of a tape and dry the put path an air soldering iron with temperature 250-350 ° With during 1-2 mines from distance of 2-3 cm to glass.
12. If necessary restore color of the damaged site iodine tincture. The restored heater can be included not less than in 24 hours.
|