Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
5.1. General information
5.2. Compression check in engine cylinders
5.3. Dismantle of the power unit - security measures
5.4. The engine - removal and installation
5.5. Major maintenance of the engine - general information
5.6. Engine restoration - alternatives
5.7. Major maintenance of the engine - a dismantling order
5.8. A head of the block of cylinders - dismantling.
5.9. Head of the block of cylinders cleanings and condition check
5.10. A head of cylinders - assembly
5.11. Shatunno-porshnevaya group dismantle
5.12. The crankshaft - dismantle
5.13. The block of cylinders - cleaning
5.14. The block of cylinders - condition check
5.15. Rods and pistons - condition check
5.16. The crankshaft - condition check
5.17. Radical and shatunny bearings - check and selection
5.18. Major maintenance of the engine - an assembly order
5.19. Piston rings - installation
5.20. The crankshaft - installation and check of gaps of radical bearings
5.21. A back epiploon - installation
5.22. Rods and pistons - installation and check of gaps in shatunny bearings
5.23. Engine start-up after repair and a running in
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








5-11-shatunno-porshnevaya-gruppa-demontazh.html

5.11. Shatunno-porshnevaya group dismantle

Attention!
Before removal of pistons and rods remove a head of cylinders, the oil pallet and the oil pump.

1. Remove a fillet in the top part of the cylinder (photo).
2. Overturn the engine and check axial люфт rods (photo), inserting щупы between the crankshaft and a rod. Axial люфт it will be equal to total thickness щупов at which люфт disappears. If axial люфт a rod exceeds standard value, it is necessary to replace a rod. If new rods (or the crankshaft) are established, люфт less norm (in this case it is necessary прошлифовать rods, if necessary consult in a car-care center workshop) can be axial. Repeat procedure for other rods.

11.2 Checking axial люфта rod
11.2 Checking axial люфта rod


11.4а Dress on bolts pieces of hoses.
11.4а Dress on bolts pieces of hoses.


3. In the absence of labels on rods and covers of rods накерните on  them number of the corresponding cylinder (photo).
4. Weaken an inhaling of nuts of covers, turning on them on 1/2 turns at one time, until then while nuts will not begin to turn away by hand. Uncover a rod of the first cylinder together with the loose leaf, the loose leaf from a cover do not take. To Vytolknita the piston with a rod and the loose leaf through the top part of the cylinder, previously having dressed on bolts pieces of hoses (photo).
5. Repeat procedure for all other cylinders.
6. Collect rods with covers, tighten nuts of covers by hand.

«previous page
5.10. A head of cylinders - assembly
following page»
5.12. The crankshaft - dismantle