Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
8.1. Specifications
8.2. Ignition system general information
8.3. Ignition system check
8.4. Distributor removal
8.5. Distributor installation
8.6. Sensor of rotation of the crankshaft check
8.7. Ignition coil removal and installation
8.8. System of start-up of the engine general information
8.9. System of start-up of the engine check
8.10. Starter removal and installation
8.11. Traction relay removal and installation
8.12. Starter replacement of brushes
8.13. Charge system general information
8.14. Generator leaving and precautionary measures
8.15. Charge system check
8.16. Generator removal and installation
8.17. Tension and brush regulator replacement
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








8-4-raspredelitel-snyatie.html

8.4. Distributor removal

1. Disconnect from the wire distributor from the ignition coil.
2. Uncover the distributor.
3. Designate situation a begunka concerning the case of the distributor (photo)
4. Disconnect wires of the sensor of rotation of the crankshaft (on cars of 198788).
5. Designate the provision of an adjusting bolt of the distributor (photo), unscrew 2 bolts of fastening and get the distributor (photo).

3.3 Drawing of a label of orientation a begunka concerning the distributor case on which the begunok should be established at assembly
3.3 Drawing of a label of orientation a begunka concerning the distributor case on which the begunok should be established at assembly



«previous page
8.3. Ignition system check
following page»
8.5. Distributor installation