13-9-salniki-perednego-reduktora-zamena.html
13.9. Epiploons of a forward reducer - replacementEpiploon of a leading gear wheel of the main transfer
1. Merge oil from a reducer case
2. Lift a front of the car and establish on supports.
3. Disconnect from a flange of a forward reducer the driveshaft.
4. Unscrew a nut of a reducer (photo), having screwed bolts in a flange and having rested a screw-driver.
5. Press a flange of a reducer (photo).
6. Hook and accurately get an epiploon.
7. Put in an epiploon universal greasing and press in a case an opravka.
8. Dress a flange, turn and tighten a reducer nut with the set moment.
9. By means of a dinamometrichesky key with a scale on some N of m check the moment of resistance a provorachivaniya of a leading gear wheel of a reducer, having turned for a nut clockwise. The moment is equal to a preliminary tightness in bearings. If the moment is less than norm, tighten a nut. If the moment exceeds norm, the rasporny plug of bearings will be damaged, a reducer it is necessary to disassemble and replace the plug.
|
8.5 Removal of a flange from a leading gear wheel of the main transfer
|
|
8.12 Removal of a flange of a semi-axis
|
10. Other operations are carried out upside-down.
Epiploon of the left semi-axis
11. Remove a semi-axis.
12. Remove a semi-axis flange, having hooked two screw-drivers (photo).
13. Get an epiploon.
14. Press a new epiploon.
15. Put in an epiploon universal greasing and press in a case an opravka.
16. Establish a flange and a semi-axis.
Right epiploon
17. Unscrew 4 bolts of fastening of the case of the bearing and the right shaft of a reducer (photo).
18. Clamp a semi-axis in a vice, having laid wooden whetstones.
19. Carefully cut down the plug from a shaft (photo).
|
8.17 Details of the right part of a forward reducer 1. Adjusting laying 2. Bearing 3 case. Epiploon 4. Ring 5. Right shaft 6. Bearing 7. Plug 8. Case
|
|
8.19 Removal of the plug of the bearing from the right shaft
|
|
8.21 Vypressovka of a shaft 1. The plug is removed
|
|
9.6 Bolts of fastening of a forward reducer
|
|
9.8 Bolts of fastening of a reducer to a frame.
|
20. Unscrew 4 bolts and remove from a reducer the case of the right shaft.
21. Establish a semi-axis in the case, tighten the case of the bearing and выпрессуйте a shaft from the bearing (photo).
22. Hook and get an epiploon from the bearing case. Press a new epiploon in blows through whetstone.
23. Remove the case of the bearing and dress on a shaft. Dress the new plug. Press a shaft in the case (it is recommended to execute in car-care center).
24. Other operations are carried out upside-down.
|