Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
6.1. Cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The sensor of temperature of liquid - check and replacement
6.10. Heating system - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Central air - general information
6.14. Central air - service
6.15. The proof-reader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






6-7-nasos-okhlazhdayushhejj-zhidkosti-proverka.html

6.7. The pump of cooling liquid - check

1. On the heated-up working engine press the top hose of a radiator if the pump is serviceable, at an otpuskaniye of a hose the liquid pressure will be felt.
2. If the epiploon is worn-out, through a ventilating opening of the pump the leak (photo) will be observed.
3. If bearings are worn-out, from the pump the howling sound proceeds, and when rocking a shaft are felt longitudinal and radial люфты (photo).

«previous page
6.6. A tank - removal and
following page»
6.8. The pump of cooling liquid - removal and installation