Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
6.1. Cooling system - general information
6.2. Antifreeze - general information
6.3. The thermostat - removal and
6.4. A radiator - removal and installation
6.5. The fan and the coupling - removal and installation
6.6. A tank - removal and
6.7. The pump of cooling liquid - check
6.8. The pump of cooling liquid - removal and installation
6.9. The sensor of temperature of liquid - check and replacement
6.10. Heating system - general information
6.11. The fan - removal and installation
6.12. A heater radiator - removal and installation
6.13. Central air - general information
6.14. Central air - service
6.15. The proof-reader of idling - adjustment
6.16. A moisture separator - removal and installation
6.17. The compressor - removal and installation
6.18. The condenser - removal and installation
6.19. The control panel a heater and the conditioner - removal, installation and adjustment
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






6-8-nasos-okhlazhdayushhejj-zhidkosti-snyatie-i-ustanovka.html

6.8. The pump of cooling liquid - removal and installation

1. Disconnect the battery from weight and lift the car.
2. Merge cooling liquid.
3. Remove the fan with a casing and belts of hinged units.
4. On V6 engines: remove a pulley of the pump and a pulley - an uspokoitel from the crankshaft, remove covers of a gear belt.
5. Unscrew bolts of fastening of the pump (photo).
6. Remove the pump, remove old consolidation.

7.3 Check pump shaft


8.5 Bolts of fastening of the pump on V6 engines


8.7 Details of the pump of cooling liquid of the V6 engine
1. For zedneprivodny and/m                                                      
2. Laying                                                                                 
3. For all-wheel drive and/m


7. At assembly grease laying germetiky and establish on faded cylinders (photo).
8. Tighten bolts evenly with the set moment.
9. Other operations are carried out in the return about. Adjust a tension of belts, wash down liquid, warm up and be convinced of lack of a leak. If necessary add liquid.

previous page
6.7. The pump of cooling liquid - check
following page
6.9. The sensor of temperature of liquid - check and replacement