Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
7.1. Fuel system - general information
7.2. The fuel filter - replacement
7.3. Idling turns - check and adjustment
7.4. The fuel highway - repair
7.5. A cable of a drive of a butterfly valve - removal and installation
7.6. A pedal - removal and installation
7.7. The fuel pump - check
7.8. The fuel pump - removal and installation
7.9. System of electronic injection of fuel - general information
7.10. Units of control and measuring system with the processor ECCS block - general information
7.11. Decompression of fuel system
7.12. The butterfly valve case (for systems with preliminary injection of TBI of systems) removal and installation
7.13. Nozzle replacement
7.14. System of injection of fuel – adjustments System of preliminary injection (TBI)
7.15. Fuel system cleaning
7.16. Tank removal and installation
7.17. Fuel level sensor removal and installation
7.18. Tank washing
7.19. Exhaust system general information
7.20. Forward exhaust pipe removal and installation
7.21. Catalytic neytralizatorsnyaty and installation
7.22. Exhaust silencer removal and installation
7.23. Average pipe removal and installation
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






7-5-tros-privoda-drosselnojj-zaslonki-snyatie-i-ustanovka.html

7.5. A cable of a drive of a butterfly valve - removal and installation

1. Remove the air filter.
2. Disconnect a cable from the case of a zaslonka (photo).

4.1 The fuel highway of engines with fuel injection
1. Tube of supply of fuel
2. Return gasoline pipe line
3. Selection tube паров gasoline
4. Control valve
5. Fuel level sensor
6. Pump
7. Laying
8. Tank
9. A tank guard (on all-wheel drive and /


3. Submit on itself a cuff and get a cable from a cut in an arm (photo).
4. Unscrew bolts of a directing tube and extend a cable through a partition (photo).
5. Installation is carried out upside-down. Grease a cuff with konsistentny greasing. Check cable work, having pressed a pedal, - the zaslonka should open completely. Adjust a cable rotating a nut of a cover of a cable. On cars with automatic transmission by pressing a pedal the rod of the switch of a low gear (switch kick-down-) should be involved completely.

5.2а to disconnect a cable of a zaslonka or cruise control unscrew nuts and get a cable cover. Then pull together couplings on loops of cables and get cables.


5.2б Pedal and butterfly valve drive
1. Zaslonka lever
2. Tube
3. Nylon cuff
4. Lock-nut
5. Arm and spring
6. Pedal
7. Lever
8. Cable
9. Collar


5.3 A cable detachment from a pedal


6. On cars about cruise - control (an automatic regulator of speed) at first adjust a butterfly valve cable, then - a regulator cable.

«previous page
7.4. The fuel highway - repair
following page»
7.6. A pedal - removal and installation