Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
7.1. Fuel system - general information
7.2. The fuel filter - replacement
7.3. Idling turns - check and adjustment
7.4. The fuel highway - repair
7.5. A cable of a drive of a butterfly valve - removal and installation
7.6. A pedal - removal and installation
7.7. The fuel pump - check
7.8. The fuel pump - removal and installation
7.9. System of electronic injection of fuel - general information
7.10. Units of control and measuring system with the processor ECCS block - general information
7.11. Decompression of fuel system
7.12. The butterfly valve case (for systems with preliminary injection of TBI of systems) removal and installation
7.13. Nozzle replacement
7.14. System of injection of fuel – adjustments System of preliminary injection (TBI)
7.15. Fuel system cleaning
7.16. Tank removal and installation
7.17. Fuel level sensor removal and installation
7.18. Tank washing
7.19. Exhaust system general information
7.20. Forward exhaust pipe removal and installation
7.21. Catalytic neytralizatorsnyaty and installation
7.22. Exhaust silencer removal and installation
7.23. Average pipe removal and installation
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






7-4-toplivnaya-magistral-remont.html

7.4. The fuel highway - repair

1. To the highway only seamless steel tubes (copper and aluminum because of a bad vibroustoychivost it is forbidden to establish) are established. At performance of any works with fuel system observe fire safety regulations. Before the beginning of works execute a decompression of fuel system.
2. If the part of a metal tube is damaged only, it is possible to cut out and replace it with a rubber hose on 1 FROM mm more long than a deleted part. Both ends of a hose fix collars.
3. If the length of a deleted part of a metal tube exceeds 150 mm, for connection it is necessary to use a metal tube with the pieces of hoses put on on the ends. The total length of hoses should not exceed 250 mm.
4. After repair start the engine and be convinced of lack of a leak.

«previous page
7.3. Idling turns - check and adjustment
following page»
7.5. A cable of a drive of a butterfly valve - removal and installation