14-19-trosy-ruchnogo-tormoza-snyatie-i-ustanovka.html
14.19. Cables of the hand brake - removal and installationForward cable
1. Release the brake lever.
2. Disconnect a cable from the lever (photo).
3. If necessary lift a back part of the car and establish on supports.
4. Unscrew a nut and disconnect the opposite end of a cable from the leveling lever (on all-wheel drive and/m) or from a regulator (on rear-wheel and/m).
5. Disconnect a back left cable from the forward.
6. Unscrew bolts of the leveling lever.
7. Disconnect all collars and remove a forward cable and the leveling lever.
8. Installation is carried out upside-down. Grease all rubbing details.
|
18.2 Details of a drive of the hand brake of the Terrano I/Pathfinder 1 car. Back cable 2. Regulator 3. Forward cable
|
Back cable
9. Release the brake lever.
10. Unscrew a nut and disconnect a cable from the leveling lever (on all-wheel drive and/m) or from a regulator (on rear-wheel and/m).
11. Disconnect a back left cable from the forward.
12. Disconnect tips of a back cable from back brakes and get tips through openings in a brake board.
13. Weaken collars and remove cables.
14. Installation is carried out upside-down. Grease all rubbing details.
|