Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and maslosjemny caps - replacement
3.10. A soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






3-18-perednyaya-kryshka-snyatie-i-ustanovka.html

3.18. A forward cover - removal and installation

1. Merge cooling liquid.
2. Remove the fan and a radiator.
3. Merge oil.
4. Remove  the ignition distributor.
5. Remove the oil pump.
6. Remove the pump of cooling liquid.
7. Remove the lever of adjustment of a tension of a belt of the generator for what unscrew the top bolt of the generator, and then lever bolts.
8. Disconnect from a forward cover vacuum and fuel tubes.
9. Remove the conditioner compressor (if it is provided) and take aside, without disconnecting from the highway.
10. Remove the pump of the hydraulic booster  (if  it is provided) and take aside, disconnect from the pump hoses.
11. Remove an inlet branch pipe of cooling liquid.
12. Remove the oil pallet.
13. Remove a crankshaft pulley.
14. Unscrew bolts and remove a forward cover, having displaced easy blows (photo).
15. Press a new epiploon.
16. Lay on a cover laying and put hermetic in the specified points (photo).
17. Grease a forward edge of an epiploon. Establish a cover and evenly in stages tighten bolts with the set moment.

18.16 Places of drawing of hermetic before cover installation


18. Other operations on assembly are carried out upside-down.

«previous page
3.17. A forward epiploon of the crankshaft - replacement
following page»
3.19. A chain and asterisks - removal and installation