Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The Dempferny cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. Vyzhimna the bearing - replacement
12.10. The directing plug of primary shaft of a check point - replacement
12.11. The driveshaft, a reducer and the back bridge - general information
12.12. Kardanny
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. A semi-axis, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






12-18-zadnijj-most-snyatie-i-ustanovka.html

12.18. Zadny Bridge - removal and installation

Removal
1. Lift a back part of the car and establish supports under a body.
2. Prop up the cart with a jack the back bridge under a reducer case.
3. Remove wheels.
4. Disconnect from a reducer the driveshaft.
5. Disconnect a cable of the hand brake and the highway of a hydraulic actuator of brakes (Hl. 10).
6. Unscrew the bottom nuts of fastening of both shock-absorbers and compress shock-absorbers.
7. Disconnect from a body of draft of the stabilizer (Гл.11).
8. Disconnect the top and bottom longitudinal bars.
9. Disconnect from the back bridge a cross-section bar (Гл.11).
10. Carefully lower the back bridge and will remove springs (procedure of removal and installation of springs is described in Hl. 11).
Installation
11. If it is supposed to replace a beam of the back bridge, remove back brakes assembled, semi-axes and a reducer and rearrange all details on a new beam
12. Installation of the bridge is carried out upside-down.
13. Pump over brakes (Hl. 10).

«previous page
12.17. An epiploon of a leading gear wheel of a reducer - replacement
following page»
13. A running gear of cars with a wheel formula 4x4