Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement of blocks
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Blocks of the hand brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. The hydraulic actuator highway - check and replacement
14.14. Pumping of brakes
14.15. The vacuum amplifier of brakes - general information and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. The hand brake - adjustment
14.18. The lever of the hand brake - removal and installation
14.19. Cables of the hand brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






14-2-obshhie-svedeniya.html

14.2. General information

Cars are equipped with brakes with a double-circuit hydraulic actuator, the vacuum amplifier and a pressure regulator
back brakes (KlSLV - the valve). The regulator is intended for an unblocking of back wheels in the conditions of sharp braking. Works under the influence of a difference of pressure in forward and back contours of brakes in reply to change of load of the car.
Forward brakes disk, are equipped with a two-piston or one-piston sliding support.
Back brakes disk or drum-type. Gaps between blocks and drums are automatically regulated at turning on of the hand brake. The design of back disk brakes almost differs nothing from a design of lobbies. The hand brake is equipped with a hummock drive, joins from the lever.


«previous page
14.1. Specifications
following page»
14.3. Blocks disk (forward and back) brakes - replacement