Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
14.1. Specifications
14.2. General information
14.3. Blocks disk (forward and back) brakes - replacement
14.4. A brake support - removal, dismantling and installation
14.5. A brake disk - check, removal and installation
14.6. Back drum-type brakes - replacement of blocks
14.7. The wheel cylinder of back drum-type brakes - removal, dismantling and installation
14.8. See hl. 1
14.9. Disks of back brakes - check, removal and installation
14.10. Blocks of the hand brake (on back disk brakes) - removal, installation and adjustment
14.11. The main cylinder of brakes - removal, dismantling and installation
14.12. A regulator of pressure of brakes - removal and installation
14.13. The hydraulic actuator highway - check and replacement
14.14. Pumping of brakes
14.15. The vacuum amplifier of brakes - general information and check
14.16. The vacuum amplifier of brakes - removal and installation
14.17. The hand brake - adjustment
14.18. The lever of the hand brake - removal and installation
14.19. Cables of the hand brake - removal and installation
14.20. The switch of a signal of braking - removal and installation
14.21. Anti-blocking system (ABS) - general information and access to codes.
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






14-9-diski-zadnikh-tormozov-proverka-snyatie-i-ustanovka.html

14.9. Disks of back brakes - check, removal and installation

1. Wrap 2 nuts of a wheel to hold a disk concerning a semi-axis flange, and check a disk condition (see section 4).
2. Remove the cylinder, unscrew bolts of fastening of a mouth to a flange on a beam of the back bridge (photo).
3. Remove a disk. If the disk does not give in, dig getting liquid round hairpins, screw bolts in auxiliary openings and wrapping bolts, remove it is wild (photo).
4. Further operations are carried out upside-down. Tighten fastening bolts with set the moment

8.2 Details of a back disk brake all-wheel drive and/m Terrano I/Pathfinder" (since 1988 } 1. Cover of a finger 2. Bolt of union З. Copper laying 4. Hose 5. Kryshna 6. Проклатв internal 7. Cover 8. Cylinder 9. Piston 10 cuff. Piston 11. Cover cylinder


8.3 Disk removal by means of auxiliary bolts 1. Boat М8х125



«previous page
14.8. See hl. 1
following page»
14.10. Blocks of the hand brake (on back disk brakes) - removal, installation and adjustment