Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The Dempferny cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. Vyzhimna the bearing - replacement
12.10. The directing plug of primary shaft of a check point - replacement
12.11. The driveshaft, a reducer and the back bridge - general information
12.12. Kardanny
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. A semi-axis, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






12-16-reduktor-zadnego-mosta-snyatie-i-ustanovka.html

12.16. A reducer of the back bridge - removal and installation

Attention!
This description belongs only to demountable reducers which fasten in a bridge beam. On it is frequent cars are established not folding back bridge which repair is carried out only in car-care center.

1. Lift a back part of the car.
2. Merge from a reducer oil.
3. Disconnect a back part of the driveshaft from a reducer.
4. Deduce both semi-axes from reducer differential (semi-axes can be not got).
5. Evenly and gradually, in diagonal sequence, unscrew bolts of a case of a reducer and take a reducer (photo).
6. The special equipment and the tool are necessary for repair of a reducer. Repair of this unit in house conditions is beyond the present description. Therefore, if abnormal work of a reducer was noted, it is necessary to replace it that is more expedient from the point of view of expenses.
7. Remove the remains of old laying and establish new laying.
8. Installation is carried out as it should be the return to removal. Tighten bolts with the set moment.
9. Fill in in a reducer oil (Гл.1).

«previous page
12.15. A semi-axis, the back wheel bearing and an epiploon - removal and installation.
following page»
12.17. An epiploon of a leading gear wheel of a reducer - replacement