Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The Dempferny cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. Vyzhimna the bearing - replacement
12.10. The directing plug of primary shaft of a check point - replacement
12.11. The driveshaft, a reducer and the back bridge - general information
12.12. Kardanny
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. A semi-axis, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






12-6-dempfernyjj-cilindr-scepleniya-snyatie-razborka-i-ustanovka.html

12.6. The Dempferny cylinder of coupling - removal, dismantling and installation

Removal
1. Disconnect from the cylinder of the union of tubes of a hydraulic actuator (photo), muffle tubes.
2. Turn out two screws and remove the cylinder.
Dismantling
3. Unscrew bolts and uncover, get other details (photo).

7.5 Order of an otpuskaniye of bolts of coupling


4. Wash out all details in pure brake liquid.
5. Check a condition of an internal surface of the cylinder. At detection of corrosion or scratches the cylinder replace.
6. Check a gap between the cylinder and the piston. If the gap exceeds 0,15 mm, replace the piston or the cylinder, having picked up details so that the gap corresponded to norm.
7. At assembly, moisten the piston and the cylinder with pure brake liquid. Track correctness of installation of all rubber details.
Installation
8. Establish the cylinder upside-down.
9. Pump over a coupling hydraulic actuator (see below).
10. Adjust height and a free wheeling of a pedal. (Hl. 1)

«previous page
12.5. The working cylinder of coupling - removal, dismantling and installation
following page»
12.7. A coupling hydraulic actuator - removal