Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
12.1. Specifications
12.2. Coupling - general information
12.3. A coupling pedal - removal, installation and adjustment
12.4. The main cylinder of coupling - removal, dismantling and installation
12.5. The working cylinder of coupling - removal, dismantling and installation
12.6. The Dempferny cylinder of coupling - removal, dismantling and installation
12.7. A coupling hydraulic actuator - removal
12.8. Details of the mechanism of coupling - removal, dismantling and installation
12.9. Vyzhimna the bearing - replacement
12.10. The directing plug of primary shaft of a check point - replacement
12.11. The driveshaft, a reducer and the back bridge - general information
12.12. Kardanny
12.13. An average support - replacement
12.14. Kardannye hinges - replacement
12.15. A semi-axis, the back wheel bearing and an epiploon - removal and installation.
12.16. A reducer of the back bridge - removal and installation
12.17. An epiploon of a leading gear wheel of a reducer - replacement
12.18. Zadny Bridge - removal and installation
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 







купить монталь настоящее золото.

12-7-gidroprivod-scepleniya-udalenie.html

12.7. A coupling hydraulic actuator - removal

1. Pumping of system is required every time after carrying out dismantling and assembly of a hydraulic actuator of coupling.
2. Zapol-fwre a tank fresh brake liquid (use of the fulfilled liquid is forbidden).
3. First of all it is necessary to remove air from the dempferny cylinder.
4. Dress on the cylinder union a hose and release in the capacity filled with brake liquid on 3-5 see.
5. Unscrew the pumping union on 1/2 turns and ask the assistant to press a coupling pedal to the full. Tighten the union, ask the assistant to release a pedal slowly. Repeat procedure until then while the hose will not cease to leave air vials.

7.8 Check of deformation of petals diafragmen-ache springs
7.8 Check of deformation of petals diafragmen-ache springs


7.6 Coupling removal
7.6 Coupling removal


6. After two, three times of pressing a pedal check liquid level. Constantly watch level, the tank should be completely filled with liquid.
7. At the pressed pedal tighten the union (do not tighten too strongly), remove a hose, restore liquid level in a tank. Execute the same operations for the main cylinder of coupling.

«previous page
12.6. The Dempferny cylinder of coupling - removal, dismantling and installation
following page»
12.8. Details of the mechanism of coupling - removal, dismantling and installation