Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
15.1. Specifications
15.2. General information
15.3. Hairpins of fastening of a wheel - replacement
15.4. The stabilizer - removal and installation
15.5. Shock-absorbers - removal and installation
15.6. Torsion - removal and installation
15.7. Bars and suspension bracket extensions - removal and installation
15.8. The top lever and a spherical support - removal and installation
15.9. The bottom lever and a spherical support - removal and installation
15.10. Springs of a back suspension bracket - removal and installation
15.11. Bars of a back suspension bracket - removal and
15.12. The stabilizer of a back suspension bracket - removal and installation
15.13. A steering - general information
15.14. A wheel - removal and installation
15.15. The lock of a steering column - removal and installation
15.16. A steering reducer - removal and installation
15.17. A steering reducer (and/m without the hydraulic booster) - dismantling
15.18. Steering
15.19. The pump hydraulic boosters - removal and installation
15.20. Air removal from a wheel hydraulic actuator
15.21. Steering drafts - removal and installation
15.22. Corners of installation of forward wheels - general information
15.23. Wheels and tires - general information
16. Body and furnish elements
17. Electric equipment system
 








15-14-rul-snyatie-i-ustanovka.html

15.14. A wheel - removal and installation

Attention.
Cars of 1996 are equipped with a safety cushion which is in the container in the center of a steering wheel. At works near inertial sensors, a steering column, the dashboard disconnect from the battery of a wire and wait for not less than 10 minutes.

1. Disconnect the battery from weight.
2. Remove or disconnect the container with a safety cushion (if it is provided), having addressed in car-care center.
3. On cars till 1994 unscrew 2 screws from the back party of a wheel (photo), on cars from 1994 of release remove the panel of a sound signal for what unscrew a krestovy screw-driver screws in the lower part of spokes and remove a collar.
4. Be convinced that the wheel is unblocked and unscrew a wheel nut.
5. Designate the provision of a wheel concerning a shaft (photo).
6. Vypressuyte a steering wheel, having wrapped stripper bolts in the special openings provided ы to a nave of a wheel on both parties of a shaft (photo). It is forbidden to remove a wheel in blows on a nave.
7. Before installation grease a back rubbing part of a wheel (photo).
8. Installation is carried out upside-down. Combine the put labels, tighten a nut with the set moment and check freedom of rotation of a wheel.


«previous page
15.13. A steering - general information
following page»
15.15. The lock of a steering column - removal and installation