Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
15.1. Specifications
15.2. General information
15.3. Hairpins of fastening of a wheel - replacement
15.4. The stabilizer - removal and installation
15.5. Shock-absorbers - removal and installation
15.6. Torsion - removal and installation
15.7. Bars and suspension bracket extensions - removal and installation
15.8. The top lever and a spherical support - removal and installation
15.9. The bottom lever and a spherical support - removal and installation
15.10. Springs of a back suspension bracket - removal and installation
15.11. Bars of a back suspension bracket - removal and
15.12. The stabilizer of a back suspension bracket - removal and installation
15.13. A steering - general information
15.14. A wheel - removal and installation
15.15. The lock of a steering column - removal and installation
15.16. A steering reducer - removal and installation
15.17. A steering reducer (and/m without the hydraulic booster) - dismantling
15.18. Steering
15.19. The pump hydraulic boosters - removal and installation
15.20. Air removal from a wheel hydraulic actuator
15.21. Steering drafts - removal and installation
15.22. Corners of installation of forward wheels - general information
15.23. Wheels and tires - general information
16. Body and furnish elements
17. Electric equipment system
 








15-9-nizhnijj-rychag-i-sharovaya-opora-snyatie-i-ustanovka.html

15.9. The bottom lever and a spherical support - removal and installation

1. Lift a car front.
2. Remove a wheel.
3. Remove торсион.
4. Disconnect from the bottom lever the shock-absorber.
5. Disconnect from the bottom lever the stabilizer.
6. Release a nut of the bottom hinge. Vypressuyte a stripper a finger of the bottom support from an eye of a fist (photo). On all-wheel drive cars the sharnirno-lever stripper (scissors type) is required.
7. Disconnect from the bottom lever a bar.
8. Unscrew a nut of an axis of the lever and get an axis (photo).
9. Remove the mobile lever торсиона and get them the suspension bracket lever.
10. Unscrew bolts and remove a support. The support not folding and in case of wear is replaced entirely.
11. If necessary beat out plugs from a frame.
12. Installation is carried out upside-down. Nuts of a support and an axis of the lever tighten with the set moment. Upon termination of lower the car and check amplitude of a kachaniye of the lever (the size H, see above). Check and adjust corners of installation of wheels.


«previous page
15.8. The top lever and a spherical support - removal and installation
following page»
15.10. Springs of a back suspension bracket - removal and installation