5-21-zadnijj-salnik-ustanovka.html
5.21. A back epiploon - installationOn 4-cylinder engines
1. Grease an epiploon, dress on the crankshaft and carefully press an opravka or in easy blows on a soft pro-rate.
On V6 engines
2. Make a mark of landing of an old epiploon on depth and remove an epiploon from the holder (photo).
3. Clear an epiploon and grease an external edge. Press an epiploon an opravka, or through two wooden whetstones, having clamped an epiploon between whetstones in a vice. It is possible to press also in hammer blows through whetstone (photo). The epiploon should come in the holder without distortions.
|
20.13 Installation of a lateral sealant on 4-cylinder engines
|
4. Grease working edges of an epiploon and establish the holder on new laying, having greased a platform under the holder hermetic (photo). Tighten bolts.
|
21.2 Vypressovyvaniye of an old epiploon
|
|
21.3 An epiploon press fitting in the holder
|
|
21.4а Greasing of working edges of an epiploon.
|
|
21.4б Greasing platform hermetic under the holder
|
|