Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
3.1. General information
3.2. Types of the repair work which is carried out without dismantle of the engine from the car
3.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
3.4. A cover of a head of cylinders - removal and installation
3.5. The roller with yokes - removal and installation
3.6. The roller with yokes - dismantling and assembly
3.7. A cam-shaft - removal and installation
3.8. A cam-shaft, support and yokes - check
3.9. Springs of valves and maslosjemny caps - replacement
3.10. A soaking-up collector - removal and installation
3.11. A final collector - removal and installation
3.12. A head of cylinders - removal
3.13. A head of cylinders - installation
3.14. The oil pump - removal and installation
3.15. The oil pump - check
3.16. A crankshaft pulley - removal and installation
3.17. A forward epiploon of the crankshaft - replacement
3.18. A forward cover - removal and installation
3.19. A chain and asterisks - removal and installation
3.20. The oil pallet - removal and installation
3.21. A flywheel (a leading disk of the hydrotransformer) - removal and installation
3.22. A back epiploon - replacement
3.23. Engine support - replacement
4. VS engines
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 






3-16-shkiv-kolenvala-snyatie-i-ustanovka.html

3.16. A crankshaft pulley - removal and installation

1. Disconnect the battery from weight.
2. Remove a radiator with a casing.

15.4 Gap check in gearing of gear wheels (1), a gap between a conducted gear wheel and the case of the pump (2), axial люфта (3) and deformations of the plane of the case (4)


16.6 Removal of a pulley of the crankshaft


3. Remove the bottom forward cover.
4. Remove belts.
5. Unscrew a pulley bolt, having included transfer or having fixed a flywheel (on and/m with automatic transmission).
6. Take a pulley by means of a stripper (photo).
7. Installation is carried out upside-down. Oil a pulley opening for the engine. All bolts tighten with the set moments.

«previous page
3.15. The oil pump - check
following page»
3.17. A forward epiploon of the crankshaft - replacement