Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








4-12-salnik-raspredvala-zamena.html

4.12. A cam-shaft epiploon - replacement

1. Disconnect the battery from weight.
2. Remove the fan and a casing, all belts, pulleys and an uspokoitel.

11.3б... or a stripper, previously having displaced an asterisk and having screwed a bolt in an opening on a crankshaft sock
11.3б... or a stripper, previously having displaced an asterisk and having screwed a bolt in an opening on a crankshaft sock


11.6 Epiploon greasing
11.6 Epiploon greasing


11.7б epiploon Press fitting
11.7б epiploon Press fitting


3. Unscrew a bolt of an asterisk of a cam-shaft (photo).
4. Remove an asterisk.

Attention!
On asterisks there are signs R (right) and the L (left), designating belonging of asterisks to the corresponding cam-shaft. If both asterisks act in film, do not mix their (photo).

5. Carefully get an epiploon (photo). Press a new epiploon (photo).

12.3 Otvorachivaniye of an asterisk bolt
12.3 Otvorachivaniye of an asterisk bolt


12.5а epiploon Extraction
12.5а epiploon Extraction


12.6 Asterisk orientation at installation on a cam-shaft
12.6 Asterisk orientation at installation on a cam-shaft
1. Adjusting label
2. Index
3. Groove
4. To a forward part of the engine
6. Having established asterisks indexes of R and L outside (photo).
7. Tighten an asterisk bolt. Other operations are carried out upside-down


«previous page
4.11. A forward epiploon of the crankshaft - replacement
following page»
4.13. Heads of cylinders - removal and installation