Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








4-9-shkiv-uspokoitel-snyatie-i.html

4.9. A pulley - an uspokoitel - removal and

1. Disconnect the battery from weight.
2. Remove the fan with a casing and drive belts.

9.4 A pulley bolt - an uspokoitel
9.4 A pulley bolt - an uspokoitel


9.5 Using partially turned out bolt of a pulley as a support, remove a pulley a stripper
9.5 Using partially turned out bolt of a pulley as a support, remove a pulley a stripper


8.12 Sequence of a tightening of nuts of final collectors 1. Right 2. Left
8.12 Sequence of a tightening of nuts of final collectors 1. Right 2. Left


3. Designate the provision of pulleys concerning an uspokoitel, unscrew bolts and remove pulleys.
4. Release a bolt of an uspokoitel (photo) for what remove a starter and fix a flywheel.
5. Using partially turned out bolt of a pulley as a support, take a pulley a stripper (photo).
6. Installation is carried out upside-down. At installation combine a shponka with a groove of a pulley and tighten a bolt with the set moment.

«previous page
4.8. A final collector - removal and installation
following page»
4.10. A gear belt - removal and installation