Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








4-8-vypusknojj-kollektor-snyatie-i-ustanovka.html

4.8. A final collector - removal and installation

1. Disconnect the battery from weight, remove the air filter.
2. Lift the car and establish on supports.
3. Disconnect from a collector a forward exhaust pipe.
Removal of the right collector
4. Take thermal guards (photo).
5. Unscrew nuts of a collector (photo).
6. Raise a back part of a collector and remove a collector.
Left collector
7. Unscrew bolts of a thermal guard (photo).
8. Disconnect a retsirkulyatsiya tube.
9. Working from below, turn on on three nuts from above and from below and disconnect an exhaust pipe (a photo 8.5).
10. Get a collector from a motor compartment.
Installation
11. Clear a collector of the consolidation remains.

8.5 Sequence of an otpuskaniye of nuts final коллекторов1. Right коллектора2. Left коллектора3,4 Forward part
8.5 Sequence of an otpuskaniye of nuts of final collectors
1. Right collector
2. Left collector 
3,4 Forward part


8.7 Details left final коллектора1. Tube рециркуляции2. Laying
8.7 Details of the left final collector
1. Retsirkulyatsiya tube
2. Laying


12. Establish on a head of cylinders new laying. Tighten bolts and nuts in the specified sequence (photo).
13. Other operations are carried out upside-down.

«previous page
4.7. A soaking-up collector - removal and installation
following page»
4.9. A pulley - an uspokoitel - removal and