Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








4-18-zadnijj-salnik-zamena.html

4.18. A back epiploon - replacement

1. Remove transmission (Hl. 7).
2. Remove a flywheel or a leading disk of the hydrotransformer.
3. Hook and carefully get an epiploon (photo).
4. Grease a new epiploon with molybdenic greasing.
5. Dress an epiploon on the crankshaft and carefully press in hammer blows with soft the brisk.
6. When the surface of an epiploon becomes aflush with the holder, carefully press an epiploon against the stop in blows on a brass core (photo).
7. Other operations are carried out upside-down.

18.3 Extraction of a back epiploon
18.3 Extraction of a back epiploon


18.6 Final press fitting of an epiploon
18.6 Final press fitting of an epiploon



«previous page
4.17. The oil pump - removal, check and installation
following page»
4.19. A flywheel (a leading disk of the hydrotransformer) -