Nissan Terrano 2 from 1985 to 1999
1. Maintenance instruction and to maintenance
2. Car maintenance
3. Четырехцилиндровыв engines
4. VS engines
4.1. General information
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.
4.4. Covers of heads of cylinders – removed and installation
4.5. The roller with yokes - removal and installation
4.6. Hydropushers - removal and installation
4.7. A soaking-up collector - removal and installation
4.8. A final collector - removal and installation
4.9. A pulley - an uspokoitel - removal and
4.10. A gear belt - removal and installation
4.11. A forward epiploon of the crankshaft - replacement
4.12. A cam-shaft epiploon - replacement
4.13. Heads of cylinders - removal and installation
4.14. A cam-shaft - removal and installation
4.15. Details of the klapanny mechanism - check
4.16. The oil pallet - removal and installation
4.17. The oil pump - removal, check and installation
4.18. A back epiploon - replacement
4.19. A flywheel (a leading disk of the hydrotransformer) -
4.20. Engine support - replacement
5. All engines
6. Systems of cooling, heating, ventilation and conditioning
7. Fuel and exhaust systems
8. System of electric equipment of the engine
9. System of decrease in toxicity of exhaust gases
10. Mechanical transmission
11. Automatic transmissions
12. Coupling driveshaft and back bridge
13. A running gear of cars with a wheel formula 4x4
14. Brake system
15. Suspension brackets and steering
16. Body and furnish elements
17. Electric equipment system
 








4-3-poryadok-ustanovki-porshnya-1-go-cilindra-v-vmt-takta-szhatiya.html

4.3. An order of installation of the piston of the 1st cylinder in VMT of a step of compression.

1. For installation of the piston of the 1st cylinder in VMT of a step of compression on a pulley of the crankshaft the corresponding marks are provided.
2. On the case of the distributor put a label under a conclusion of a wire of a candle of the 1st cylinder.
3. Uncover the distributor.
4. Turn the crankshaft so that the mark in a pulley was combined with the index (photo).
5. If the begunok indicates a label put on the case of the distributor, the piston 1 - го the cylinder is in VMT of a step of compression. Otherwise tighten the crankshaft on one complete revolution clockwise (360 °) and establish the piston 1 - го the cylinder in VMT of a step of compression.
6. Now it is possible to expose in VMT of a step of compression and other pistons, turning the crankshaft on 120 ° and observing an operating procedure of cylinders.

«previous page
4.2. Types of the repair work which is carried out without dismantle of the engine from the car
following page»
4.4. Covers of heads of cylinders – removed and installation